HP8753C MANUAL PDF

The clue was something I just read on the Keysight forums - that Aha, that is also the offset of these spurs from the CW. Initially I thought my routing of the external monitor cables was the issue. Big improvement in all except the kHz spur which gets worse for some reason.

Author:Kajiran Mitaxe
Country:Great Britain
Language:English (Spanish)
Genre:Medical
Published (Last):9 November 2013
Pages:278
PDF File Size:9.37 Mb
ePub File Size:2.69 Mb
ISBN:119-1-92757-884-7
Downloads:29607
Price:Free* [*Free Regsitration Required]
Uploader:Moogudal



The clue was something I just read on the Keysight forums - that Aha, that is also the offset of these spurs from the CW. Initially I thought my routing of the external monitor cables was the issue. Big improvement in all except the kHz spur which gets worse for some reason. The key question is does this affect the device? I have noticed some very occasional glitches in the CW signal, which makes me wonder if the spurs are high enough to confuse the phase lock.

Apart from that everything seems comfortably better than spec. Its ex Colorado Uni and by the look of the dings in it, it has taken some punishment. Pulled the cover off it - it has little plastic zip slider things, no screws.

Opened up the directional bridge and wow, it is a thing of beauty inside. Wish I had a better camera. Old repair RF input comes from the right via the choke, bottom is test port, left goes to reflected A output to VNA, top goes to termination resistor.

Tiny Termination resistor at the end of the line from the Test port. Heads left via the choke to the coupler Resoldered cap visible. Lower right is bias input.

30RB AQUASNAP PDF

8753C Network Analyzer, 30 kHz to 3 GHz

That oscillator is a 3. Cleaning works I have done also some cosmetic work on the unit and have also fixed the gummy power button system. To do that, I have got out the display assembly, have carefully cleaned it, and then have cleaned and greased the power button mechanism: Source adjustments As I said before, I was afraid of trying any test which would write on the configuration EEPROM, as I had no way to restore the previous configuration if things got worse But I could not find it for a while, until I got the info from another manual of an C, where it was pictured. Here you have the previous apparently good check of the YO coil drive, which showed some offset: And now this is the same signal after the pretune changes: As you can see, I was right about the offset being an anomaly. I did also some CW tests and, as a sample, a 1.

MANUAL AMPTRON PIII-3748LMRT PDF

Keysight 8752 and 8753 Documentation Catalog

Gardamuro More to come soon Unit as received I got the unit knowing it had several faults, so there was not surprise when I got the first display from it: So I went bed at about 3AM local time To check my theory, I soldered a new 0. Here you have a test pattern displayed on the Sony monitor subassembly yes, it is a Sony Trinitron tube! Source adjustments As I said before, I was afraid of trying any test which would write on the configuration EEPROM, as I had no way to restore the previous configuration if things got worse I got a gut feeling that the problem may be with the power supply itself. So I removed the switching pre-regulator box and opened it in a hope to find the answer there. The bad C6 bypass capacitor was replaced with a new mica red one which can be seen in the center of the picture.

DAVID SKLANSKY THEORY AND PRACTICE PDF

EB5AGV's Workbench: HP-8753C repair

.

Related Articles