LSI 9240 PDF

We are going to use the sas2flsh program to perform the update. Enter the command sas2flsh -o -e 6 This command will put the card into advanced mode -o and then erase the flash memory -e 6. Erase Flash Operation Successful! Resetting Adapter Reset Successful! Finished Processing Commands Successfully.

Author:Zoloktilar Shakajinn
Language:English (Spanish)
Published (Last):2 December 2017
PDF File Size:18.22 Mb
ePub File Size:1.50 Mb
Price:Free* [*Free Regsitration Required]

Plugged in the LSI controller, all I get was that blinking cursor. One other thing; when it was working I entered the LSI configuration interface and did a new configuration but never saved it, I hit Cancel on that. I doubt that the problem can came from there. Any ideas? I can provide screenshots if it helps. Was the raid working? Did you create a new raid and then not save the configuration?

Start over with a clean box, remove the drives, and the raid adapter, can you get post? What is the Machine type and model from the sticker, it will be in XXXX-xxx format above the serial number. I tested today the LSI controller on a real HP server and is doing the same, having a blinking cursor on the left upper corner.

Hope this files up the gap, if not let me know. Here are a couple of postings on a different forum, hopefully one of them will work for you. RE: LSI 8i blinking cursor in the left upper corner OP 8 May 14 I taught about the firmware upgrade but the server is stopping at the controller screen, so no can do.

Is not about the ICH10 cipset right now because I also test it in an enterprise server. Like in the attached screenshot ignore the BIOS version and other stuff, I will take a real picture tomorrow if needed. I taught it will have a "time out" and pass this, give an error message, but instead stays here until I power of the computer.


Firmware für die LSI 9260-8i SAS-RAID-Karte



LSI 9240 8i: RAID 10 slow perfromance


Related Articles