Page 2 - Coordinated defrost via data communication Contents Introduction Page 4 the compressor operates for a longer time and pulls the S5 temperature further down. When the temperature passes a set allowed variation the defrost will be started. Page 5 A special moulding technique unites the hard front plastic, the softer buttons and the seal, so that they become an integral part of the front panel. There are no openings that can receive moisture or dirt.
|Published (Last):||23 September 2004|
|PDF File Size:||11.47 Mb|
|ePub File Size:||5.54 Mb|
|Price:||Free* [*Free Regsitration Required]|
Page 3: Operation Here the temperature reference is changed easily with a contact signal on a digital input. The signal raises the normal thermostat value by a predefined amount. At the same time the alarm limits with the same value are displaced accordingly.
Page 5 If it is necessary to indicate the temperature on the front of refrigeration appliance, a display can be mounted. There are several other functions for the alarm function as well as the light control, rail heat control and fans. Please refer to the respective settings. Page 7: Survey Of Functions When the function is changed to ON the thermostat differential will be increased by the value in r Activation can also take place via input DI1 or DI2 defined in o02 or o Display step Disp.
Page 12 If the function is controlled by a signal at the DI1 or DI2 input, the relevant status can be seen here in the menu. Selection of application Appl. Mode only output in Danfoss The controller can be defined in various ways. Here you set which of the 3 applica- only tions is required.
Only the function belonging to the selected applica- tion is shown. Page 14 The information can be found in o65 or o66 a couple of seconds after copying has been started. Page 15 Semihermetic Compressors c02 min.
Danfoss EKC 202 Manual
Danfoss EKC 202D Manual